This dress started as Knipmode dress 12 from February 2011. It only needed hems but I wasn’t happy with how it looked. It was too large and the back neck facing refused to lay flat (I’m never going to use this method for finishing a back neckline again, it just doesn’t work with knit fabrics.). I suppose I could have fixed it but I didn’t think the shape of this dress was working for me either so my motivation to get it finished had completely disappeared.
I decided to turn it into a Lady Skater dress instead. This would not have been possible if I hadn’t had about 1 meter of fabric left-over. I was able to cut out the back skirt from the back and front skirt of the Knipmode dress, but had to add a centre back seam in the process. The front skirt, front and back bodice and one sleeve were cut from the piece of left-over fabric. That left me 1 sleeve short. There was absolutely no way I could squeeze it out of the fabric in one piece. My options were to either change to short sleeves or piece the sleeve. I think an unnecessary seam in a sleeve isn’t very desirable. It’s bad enough I had to create a centre back seam for the skirt so my solution was to turn it into an asymmetrical colour block dress! I used some olive green single jersey for the bottom part of the right sleeve. I think it adds an interesting touch. Do you like it or do you think it looks as if I didn’t have enough fabric?
I did make some changes to the pattern pieces before I cut the dress out of fabric to improve the fit even more compared to my previous version and I thought it would be nice to show you what I changed and how that affected the fit.
At the top of the front bodice there was a little bit too much fabric that created some wrinkling. I used some pins to pinch this excess fabric out on my test version dress and transferred the amount of fabric that was pinched out to the pattern piece by folding the pattern the same amount. When you look at the before and after picture below you can see that the fabric in my new dress is much smoother in this area.
At the top of the back bodice there was also some excess fabric. I solved this the same way as I did the front bodice. (I apologize for not using a picture of the same shoulder.) Since the changes I made to the front and back bodice also affected the length of the neckline I also shortened the neckband by the same amount to make sure that it would still fit correctly.
In my test version I had already slimmed down my sleeves somewhat and this had improved the fit but there were still a lot of drag lines. I suddenly realised that my arms were much skinnier than what this pattern is made for and that there was simply too much fabric in this sleeve, especially on the front of my arm. Again I used pins to pinch out the excess fabric and transferred this to my pattern piece. Additionally, I slimmed down the sides of sleeves a little bit as well (using a good fitting sleeve from another pattern as a guideline). I also made the sleeve pattern longer to get rid of the sleeve band.
I am much happier with this dress than I was with the original one and I think I’m going to wear it this Christmas. I still have quite a bit of small pieces of fabric left-over since I didn’t use the original bodice and sleeves for my new dress. Perhaps I’ll be able to turn those into a baby top to get this UFO busted even more.